Home > Lightnin' Grip Loader >

(#13) WALTHER P22/P22Q / SP22 /G22 Bull Pup Rifle/Phoenix Arms HP22a Magazine Adapter Only
(#13) WALTHER P22/P22Q / SP22 /G22 Bull Pup Rifle/Phoenix Arms HP22a  Magazine Adapter Only
 
Price: $8.00


Product Code: WALTHER-P22-ADAPTERONLY
Qty:

Description
 
WALTHER P22 /P22Q / SP22/ G22 Bull Pup Rifle / Phoenix Arms HP22a mags. Adapter Only

WALTHER P22 /P22Q / SP22 / G22 Bull Pup Rifle / Phoenix Arms HP22a MAGAZINES.

(Downloadable PDF)

Hold the loader in your left hand, and press the adapter lock with your thumb. With your right hand, hook the Mag Adapter into the top of the Lightnin' Grip Loader and swing the bottom into the slot. Take your thumb off of the lock button. it should pop out to the locked position when the adapter is in fully seated.



Insert your magazine into the adapter until it latches into notch.


To remove the magazine, while holding like pictured here, gently press down on latch and pull out.





LIGHTNIN' GRIP LOADER INSTRUCTIONS



1.) Slide open the Bullet Reservoir Cover and drop in up to (50) 22LR cartridges.


2.) Close cover. Gently shake the Lightnin' Grip Loader, keeping it level and
the reservoir cover on top.


3.) Raise the reservoir end to slide the cartridges in to the Loading Channel.


4.) Repeat #2 and #3 until the Loading Channel fills sufficiently.



FILL WITH AMMO

5.) Raise the reservoir end and smoothly squeeze the trigger to load a round
into the magazine. The trigger needs to return to the nearly out position to
seat the round and stage another bullet for loading. It is usually a good idea
to count the bullets going in to know when to stop. It is possible to force in an
extra round.

NOTE: Quickly snapping the trigger in can cause the bullets to bounce in some
magazines and "hook" the rims in the wrong direction making them hard to get out.
Sometimes a hard rap on the bottom of the magazine with your palm or on a book
will bounce the bullets to unhook them.

ALIGN BULLETS
TIPS:

Some 22LR cartridges are real sticky with wax lube. After filling the reservoir, give
them a shot of Remington (Rem Oil) Teflon Spray Lube. Only a small amount is
needed.

CAUTION: the unit is molded from Lexan, and some lubes will attach it.

Not all magazines fit the same; you may need to apply a little seating pressure
against the magazine as you are loading it. As Pictured here.

Periodically take a look at our website for updated tips.

HOLD MAG SEATED AND SQUEEZE TRIGGER.

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 Excellent Adapter June 14, 2020
Reviewer: Ronney Le Compte from Broken Arrow, OK United States  
Used this on my Walther P22 magazines -- Lightnin Fast -- Excellent -- 100% reliable.
A must have accessory if you have a P22 !!!!!

Was this review helpful to you?